Router Table Bit Depth Gage

I needed a depth gage for raised panel bits for easier setup later on my router table.   Most all I could buy were too narrow and too shallow.  This model is based off using a PEC Tools 6 inch 4R Rigid Certified Rule (402-006CT) .  The rule width is 0.717" and thickness is 0.043"  This model is based on this size of rule.  You may have to modify the slot to fit the ¾" rule you are using.  It is captured in place with a cover plate that is held in with (4) #6-19 rolling thread screws for plastic.  I only print with PETG but I am sure you can print in any material you desire.  This model was printed using 0.2mm Quality print setting with 30% infill.  Also included a gage block just for fun.  I hope this helps others.