Gridfinity Desk Organizer System - Deskfinity

Printed great in PETG. I plan on printing more in PLA.

Looks great, using a 3x4 Gridfinity Desktop Baseplates as baseplate (edited)

Merci pour le partage!
Ce serait presque parfait mais j'ai un soucis à l'impression, qui je pense pourrait être résolu avec un meilleur paramétrage de PrusaSlicer: les trous en dessous des éléments (qui servent à insérer les aimants 6x2) s'impriment mal, car le périmètre circulaire s'imprime dans le vide, j'ai fait une capture d'écran pour illustrer le problème. Le résultat devrait déjà être un peu meilleur si le remplissage (bleu clair) s'imprimait avant le périmètre circulaire (bleu foncé), savez-vous comment paramétrer cela?

PLA Prusament Gravity Grey
0.2mm layer

Perfect system, i need to print more bin :)

Easy to print, looks good and so fun to change modules when needed

Nice set of modules that print well and look very clean. Thanks!

Good stuff! I printed the card holder, sticky note tray, and the 8 + 1 container... thing. Super useful, along with other Gridfinity prints I slotted into my setup.

Thanks, Worked great!

Printed the pen tidy, really simple and clean design, thanks!

Pretty good, but like some others have said, the pen holder-looking grid ones don't work well. I wish I had realized when slicing that it wasn't very tall, I would have scaled it up a bit.

USB flash drive holder is a good concept but doesn't work for USB-C, and you do have to remove the caps from / extend your USB-A connectors. I understand this, because USB flash drives are all different sizes while the USB-A connection point is uniform, but I'm only keeping sticks I don't care about too much in it, as I don't want to risk damaging my really nice Samsung drives and would rather leave their caps on, so I removed that drive from the holder after taking the photo. (edited)