This two-part clasp is fits specific magnets (see below) and allows you to put on your bracelet with one hand!
20
80
1
722
updated January 21, 2023

Description

PDF

These are bullet/pill-shaped bracelet clasp magnet HOLDERS only, and will not work properly without magnets. However, there is a small male/female design feature which is non-magnetic. 

This model was designed to perfectly fit some 3x6mm disk magnets I bought from Harbor Freight (which appear to now be discontinued). Each piece of the clasp only fits 1 magnet, which can be held in place by super glue. 

The other end of the clasp pieces can be used to feed a bracelet string through (see photos). This is a far superior clasp method to the sliding knots commonly found on these leather bracelets. The strings/ends can also be held in place by super glue. 

If you look very closely, you may notice that this clasp is a bit over-engineered, because I built in some features that proved to be unnecessary. But it works fine by attaching with super glue as described.

Because these parts are so small, I strongly recommend printing with the rounded tip into the air, AND INCLUDE A BRIM.

Tags



Model origin

The author marked this model as their own original creation.

License