Purge bushing for A30T. I used different files but didn't want to unscrew the bolts on the Z-axis, so I matched the X-axis motor cover with a 10mm limit switch offset and a basket. I changed the nozzle to stainless, but it is longer than the standard one. Therefore, I dropped the basket below. I think that if you use a standard nozzle, then you just need to make the silicone insert above. Good luck to all.
Thanks https://www.thingiverse.com/thing:4731557 https://www.thingiverse.com/thing:4182279
Printer:
Geeetech A30T
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
25
Filament:
FD Plast PETGBlack
Category: OtherThe author marked this model as their own original creation. Imported from Thingiverse.