Reinforced and Easier to Print Rotating Face Shield - US Version

Thanks to Cavy for the original remix. It is exactly what I've been looking for. I work 12 hour shifts with a face shield and it's much easier to flip it up to get a drink than to take it off, set it down, and possibly forget it.

This version reinforces the area around the pivot hole and increases the size of the pivot hole slightly. I had difficulty printing the original because the end prints as an island at the beginning and it would often come loose during printing. I also had trouble getting the hole to snap onto the pivot pin without breaking the end of the visor. This remix solved both problems with me.

Included are the original headband piece, the reinforced visor holder, and a resized buckle that snaps over the headband mount so 3/4" elastic can be used as a headband if you don't have the type with holes in it.

Print instructions

Supports are needed under the pivot pins. Use support enforcers under the pins to make life easier.