Airsoft keymod rail 35mm

I created this because I know that this is a part that I will need in the future for my airsoft attachments.

Print it with 0.2mm layer height, 10mm brim and supports enabled. Print this from the side that is touching the gun when attached otherwise the top surface will have very bad quality and you might have problems attaching accesories to it.

I will make various lengths in the future and i also plan to make that small keymod part that locks it in place. Obviously these parts are best made from aluminum but maybe platic will work as well.

10/03/2023 - I have added a simple version to make printing it a lot easier, the only disadvantage of the simple version is that the on the normal version there are these “guides” at the bottom which make attaching it to the weapon easier. When i was looking back at the old gcode i have also realized that you don't even need to use supports for the hole, you can use sacrificial bridging instead. I have changed that in the new gcode that i added as well. All you have to do after printing is just cut out the small pieces of filament inside the hole.