This is a simple case for theShelly H&T sensor.
One Base is with mounting points for a step down module one is without them.
Both come with a 4mm hole for a USB Cable.
The Shelly H&T twists into the lid like in the original case
As the Shelly H&T only is rated for 3V you should use some type ofvoltage regulator!
additionaly needed:
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0.15
Infill:
15%
Category: ElectronicsThe author marked this model as their own original creation. Imported from Thingiverse.