Case for Light and Fan Switch and USB

This is a case I made to control the lights and fan in my printer enclosure.  It also has a slot for a usb extension cable to relocate the usb drive from the side of my Prusa Mini+ to the side of the case.  It fits two full size rocker switches.  The size of the cutout for the switches and usb extension cable is found in the pictures.

Here is a link to the usb cable that I used. 

https://www.amazon.ca/dp/B003YKX6VS?psc=1&ref=ppx_yo2ov_dt_b_product_details

Three 2.5mm screws are needed, one to secure the USB cable and two to secure the front panel.

The front panel should be printed on its back and supports are required.  The default supports in PrusaSlicer worked fine.

The back panel should be printed on it's back, no supports are required for this piece.