Collection of Voron 0.1 Mods

This is a collection of Mods on Voron 0.1. Designed / re-designed by me.

• Frame of 15mm height between frame and top-hat. Reason is to integrate LED lights and raise the height a bit for not kinking the cables and PTFE tube. 3 stls.
• Motor_Frame for extruder pancake motor (LDO). Left upper hole is for 4mm screw instead of 3mm. Lead to malfunction after few hours. I corrected to 3mm, printer runs sufficient since this exchange.
• DoorHandle reworked for a continuous double adhesive tape. Handle is very good attached now.
• LinkReinforcements to link the skirts underneath. Always attached between two halves. You need to drill holes underneath, countersink them. Gives good reinforcement.
• RaspBerryCam-Holder, two parts: Part 1 adhered by double adhesive tape to the acrylic housing, Part 2 holds the WebCam. The one with a long onbjectiv.
• a) ProfileCovers printed in TPU make your printer look nicer, prevent debris falling into the grooved. b) ProfileEndCap closes the upper end of aluminum profiles.
• PTFE Clamp holds your PTFE tube in place. My tube slipped out or in while loading resp. unloading. Is definitely clamped now.

Print Settings

Printer:

Prusa, Voron0.1, Voron 2.4

Rafts: 

No

Supports:

Doesn't Matter

Resolution: 

0.2mm

Infill:

20-25%

Filament:

Doesn't matter PETG, ABS, TPU, PLA 

Notes: Choose material i.a.w. the part's requirements.

Category: 3D Printers