!!!New!!! sitting Creality Rabbit with filament ears

Sitting and laying Creality Rabbit with filament ears!

If you like it --> press like it :-)

Like the simple design of the original and wanted to remix it. Because I wanted to have more control on the model, I reconstructed the Creality Rabbit, gave it more detail at the feets and made also a sitting version of it. Of both poses, there is a sharp and a smoothed version and also one with ears that you can print it fully like the original one.

The ears are two pieces of filament, which will be put into printed holes.

Just cut it into a length of 65mm and press them in. There is a geometry in the hole which will hold the filament.

I had some 1.6mm aluminium wire at home and it makes it more classy than with filament 😉

If the filament goes to hard into the holes, print it slightly bigger.

The print in white color is not a good choice to show a print, but in reality it looks very nice.

Would be happy to see your makes!