A top and bottom support to mount the RMU Mk3 with Top mount ports to the Prusa Original Enclosure. This fits inside the case on the right hand side. There is enough clearance to install PTFE tubes and open the lid.
Look at the picture for installation location. Make sure to use the two holes shown in the picture. There is also one mounting hole on the bottom edge of the case. Loosely thread them all into position, then snug them into place.
Uses spare nuts and screws from the Prusa i3. Everything is M3.
I printed them in PETG. Probably works fine with PLA.
The author marked this model as their own original creation.