Home Assistant raspberry pi w/ poe case

I customized a raspberry pi w/ poe case to include the Home Assistant logo
4
27
0
463
updated January 7, 2023

Description

PDF

I followed https://www.youtube.com/watch?v=0Sla-vIsvh4 to add a colored inlay to the case:

  • Arrange both models in your slicer so that the inlay fills the void in the top (if you center both models, it should be a 23.7mm offset to get them perfectly aligned)
  • Slice and print just the inlay. You might want to tweak your slicer settings to print a little slower for better build plate adhesion
  • Once the first print is done, quickly start heating your build plate again to maintain adhesion
  • Slice and print the top in the correct position with zhop set to at least 0.3 mm (assuming your initial layer height is 0.2 mm). That'll push the print head up to 0.5 mm, which should just clear the inlay which is 0.4 mm.

Model origin

The author remixed this model.

Raspberry Pi 4 PoE Case
by Slaur (thingiverse.com)

License