Replacement Drive Gear and Gear Cone for the FilaWinder in order to easily hold the Bambu Lab printable spool.
The files with the suffix of Base are just there for your own re-mix and aren't used in the build.
The bearings used are 608 ZZ Ball Bearings
https://www.amazon.com/dp/B08DR6L5CJ
The magnet is a 6x6mm.
https://www.amazon.com/gp/product/B097Z5LTZQ
In addition to the bearing, put the magnet into the 1/4″ hole on the flat side of the large gear. The north pole of the magnet should face out. If you leave the magnet on its side on a table and flick it a couple of times, it will spin and stop with the north pole facing to the north.
Information on the FilaWinder:
https://www.filastruder.com/collections/filastruders-accessories/products/filawinder
https://www.thingiverse.com/thing:174383
The author marked this model as their own original creation.