Anker A8346 Dock - W I D E Remix

Remixception of a SlavaSlenin's remix of the original Anker SteamDeck Dock by Danol. Modified to fit my SteamDeck inside a Spigen case, but it might work with some other thinner cases. 

Print process was a bit of trial and error, despite having a caliper and a rough idea of how much I wanted to move stuff around. Used Tinkercad to splice and adjust the model. 

Idea is to print SlavaSlenin's base and then use the suggested infill settings provided in Danol's original:

Tolerances were made for printing at 0.3mm layer height.

IMPORTANT! Print the top piece as mesh, if the hubs are fully enclosed they will 100% overheat! (top layers: 0, bottom layers: 0, wall line count: 8, infill pattern: lines, infill density: 20% or less) 

I printed at 0.2mm height, but followed the settings above. Used an infill of about 15% from what I recall in sparkly-grey PLA with pretty good results!