Bambu X1 P1P Horizontal Spool Holder

An updated side spool holder that I did for the X1.  This one is 10mm shorter and the filament feed hole is 20mm lower, making it feed a little easier. 

Designed to fit the P1P, with a 90-degree mount for the connecting coupling.

I printed this in PLA, 5 wall, 5 top and 5 bottom at 25% infill.  

To mount I use some M3 x 20mm cpa head screws, to mount the 90-degree coupling part, I just used the original screws that were in the filament holder.

The holder will still fit the X1.. and I'm now moving over to this design on them all.