the dispenser itself holds 7 cups with the short extension it holds 10. A dispenser with 2 normal extensions it can hold 20 cups. But you can shuffle it deepening on your needs
2 different cups can also be put in the same "lane" so you can take one form the top and the other form the bottom
the opening at the bottom is slightly smaller than the cups and makes a little indent when removing the cup. But this has no affect on the overal function because the cups wil be pressurized in your machine removing the dent.
it uses 8x3 round magnets that can be inserted in the hexagonal pattern.
you need at least 1 magnet per extension and 5 for the dispensing part (4 below and 1 above).
Printing
layer height 0.15mm
First layer height 0.3 (for better bed adhesion because it is a pretty long piece)
infill 15% Grid
material: would recommend a moisture resistant plastic like PETG. since it wil probably be next to a coffee machine some water vapor can be expected.
Filling the entire print bed with parts is not recommended sinds the corners of the bed are slightly colder and can result in warping.
The author marked this model as their own original creation.