This is concept design of Ipad Pro 11 I-gen divided case.
Ipad is to large to print this in one piece on my MK3S so I designed this case in two separate parts.
Link is fitted quite accurate so if it is to tight it might be good to reprint this with changed z-high to 1,3mm.
MODEL NOT TESTED YET!
Every suggestion are welcome.
Material for bottom and top case: PET-G, TPU-( recomended higher stiffnes-97A Shore), ABS, ASA
Material for Link: PET-G, ABS, ASA ( PLA not recommeded)
Layer high: 0,1 - recomended
Supports needed for overhangs in both case parts
The author marked this model as their own original creation.