I needed a holder for my the shower head in the bathroom. First attempt was a simple version based on my soap dish and basket. Although this worked fine for several month, I always had the impression that it might fall off eventually, because the shower head forms quite a lever and pulls on the simple rod clamp.
Therefore I decided to design a sturdy version, where the rod clamp can be secured with a screw.The shower clamp is tilted 45° with this version and the shower clamp is 3cm high and has a diameter of 23mm on the upper side and 21mm on the lower end to firmly hold the shower head. If you need a different angle, leave a comment, I might upload a remix if requested.
Unfortunately I couldn't come up with a design that doesn't require any support (as I did for the simple version), But to reduce the amount of required support I cut the double-clamp in two parts which must be glued together (guide pins should help proper positioning). If you prefer to avoid gluing, the double clamp is also uploaded as a single piece.
As the thin TPU layer provides excellent grip on the rod, I didn't design a remix that can be printed in PLA only. If you want to try one, leave a comment, then I might upload another version for pure PLA or PETG without TPU.
----
Update 2024-11-19: Added a version for 16mm rail (also 45°) with slightly thicker TPU layer and wall thickness of the rail clamp increased from 4mm to 5mm. Otherwise the threaded arms are a bit to thin. (@PhilippeM_2612311 please give it a try and let me know if it fits your rail)
The author marked this model as their own original creation.