Modern Jet Turbine Fan Fidget Spinner

This is the modern version of my other Jet Turbine Fan Fidget Spinner.

I designed this to resemble todays' "Fan" section of a jet turbine engine. Simply blowing on it will spin it.

The fan is directional. Due to the curve of the blades, blowing on it from one side vs the other will make it spin much faster. Just holding it to the air vent in your car with the blower on high will spin it a lot.

The arrows show the direction of air flow for optimal rotational velocity.

Requires 1, 608 (22mm) bearing.

Please post your comments and makes!

Try this spinner on my pinwheel stick! https://www.thingiverse.com/thing:2350624

*Use my Spinner Press to help insert the bearing and center caps. http://www.thingiverse.com/thing:2275122*

Print Settings

Printer:

Hatchbox Alpha

Rafts:

No

Supports:

No

Resolution:

.20mm

Infill:

20%

Notes:

No rafts or supports needed.

It took 59 minutes to print on my printer using the above settings. I print at 195C with a bed temp of 60.

Category: Toy & Game Accessories