Purdue Hammer

Modeled from scratch using my own machined hammer made in the ME 263 course at Purdue!

Boiler up, hammer down, hail Purdue!

Print Settings

Printer:

Tronxy X3

Rafts:

Doesn't Matter

Supports:

No

Resolution:

0.1

Infill:

20

Filament:

Overture PETG

Black

Notes:

Handle printed in vase mode (spiralized outer contour) completely upright with 0.2 mm layer height and a large brim, but could theoretically be printed with infill or even solid. It's 295 mm tall so it just barely prints in my 300 mm tall build space!

Hammer head printed with ~20% infill and 0.1 mm layer height. Offset of the hammer head and handle is about 0.2 mm so the fit should be nice and tight but not too tight.

Only issue I need to fix is the hammer handle doesn't have a top layer if printed in vase mode, so I might reduce the height of the handle and add a cap-like part to put in the top of the hammer head.

Category: Scans & Replicas