This case for the Rock5B features a big ol' hole on top for the Low Profile Ice Tower heat sink.
Materials Needed:
- Four screws at least 14mm (I used M3 x 14mm) plus nuts
- Four M3 x 4mm screws
- Radxa Rock5B with mounted heat sink (printable found here)
Assembly:
- Place Rock5B on standoff and push the M3 x 14mm screws up from the bottom. Secure with the nuts
- Slide top on, being careful not to break the delicate bits
- Secure top with the M3 x 4 screws
Printing Recommendations:
The sides and rear are 3mm thick, but the front is only 2mm, so be cautious, as the thin bits can easily be broken off.
Tags
The author marked this model as their own original creation.