This is an adapter to use a t8 lead screw on a Da Vinci printer. The printer will either need to be flashed with repetier firmware or have a new control board.
I used an anti backlash t8 nut.
After printing tap the 4 holes for the nut with a 3mm tap. Use 10mm long screws. Use a 8mm to 5mm flexible coupler.
Change the eeprom z steps per mm to 400.
Rafts:
No
Supports:
No
Infill:
100%
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.