Spout For Splash Free Pouring (DIN Ø50mm)

Needed a simple spout to pour IPA without splashes. 

Fits a ø50 mm threaded plastic container. Pitch is 4 mm, height about 12 mm. 

Prints nicely with PLA or PETG with a 0.3 mm layer height.
Since print time is short, I would recommend to use light supports and a brim.

Update 20221221:
Added a gasket since IPA is “very fluid” and drips through the thread. You will need a rubber seal of about ø40x3 mm. The gasket ring is printed separately. After adding the rubber seal, it gets simply screwed into the spout. Should it be too loose, you can add some glue on its thread.

Update 20221223:
Small adjustment on the gasket ring (v11).
Added a 90° rotated sprout, depending on the thread (Spout_90deg_v11).