Hinge Pin and Clip for Multi-Use Case with Inserts

I wanted to print this case at 200% size, but as a consequence I could no longer use a piece of filament as the hinge pin, so I designed one myself that will fit the case at this scale, and a 400% scale one if you scale the pin and clips by 200% and so on, you get the idea : )

Don't forget that you need to print two clips ; )

Print Recommendations:

• For the pin, I found it easier to print it properly vertically, but I recommend using a brim to avoid it falling over during the print, and having the z seam alignment set to user specified had the best results for the finer details.
• I printed everything at 0.2mm layer height.
• Printing the pin vertically may reduce it's overall strength, but it took me a lot of force to snap it off by pulling on the lid of the case, so I wouldn't worry about that.

You can find the case made by JamesThePrinter for which I designed this pin and clip here → https://www.printables.com/model/243424-multi-use-case-with-inserts

Hope this will be useful for some of you <3