Case and mount for BTT HDMI5 screen for a 4040 extrusion end cap. There are two fronts - with or without a sign. Two signs - “Ender3 belt“ and blank. Two mounts - swivel and fixed. Both tilt.
I used 90 deg connections but straight one worked too. You will need some M3x5x4 heat sets (voron spec ones), a selection of M3 bolts and a couple m3 nuts. You can reuse the M5x8 bolts that were holding the stock screen in place.
The back piece has sacrificial layers in the holes that the screen mounts too so you can avoid supports. A sharp knife or a 3mm drill will clear those easily.
The author marked this model as their own original creation.