SBox Craft Paint Inserts

An insert intended to hold crafting paints and paintbrushes in Michal Fanta's SBox design.
19
70
1
662
updated December 6, 2022

Description

PDF

This is an insert for the SBox for MK2/3. The insert is made to hold 2oz crafting paints and requires either the medium or large box.

Important Printing Options

I've found the Arachne generator to not properly slice this model. The Arachne engine will create some very thin walls that shouldn't interfere with the operation of this holder, but are likely to break off.

  1. In PrusaSlicer, go to the Print Settings tab. 
  2. Enable Advanced or Expert view. 
  3. Under Layers and Perimeters, look for Perimeter generator
  4. Set to Classic

Files

  • Paint 5x6.stl - This model holds qty 30 2oz craft paints. The paint is held loosely enough that it is easily inserted and removed from the printed model. The model is a fairly tight fit into an SBox and should remain in place. However, the model is flexible enough that it can be inserted into and removed from the SBox without significant trouble. This model is intended to be used in a medium SBox or as the bottom layer of a large SBox. The paint bottles are too tall to stand up inside of a small SBox.
  • Paint Brushes and 3x6.stl - This model holds eighteen 2oz craft paints as well as multiple paint brushes. This model is intended to be used in a medium SBox. Like the above model, this should fit tightly into an SBox and remain in place until you intentionally remove it.
  • Paint Brushes and 2x6.stl - This model holds twelve 2oz craft paints and paint brushes. This model is intended to be used in a large SBox as the upper level (with a Paint 5x6 in the bottom). 
  • Handle.stl - This is a handle to be used with Paint Brushes and 2x6.stl. Use an M3 screw, up to 40mm in length, to attach the handle.

Tags



Model origin

The author remixed this model.

License


Highlighted models from creator

View more