A mount for the Biqu H2 on the Ender3 v2. It also includes spots for a BLTouch, and the BTT SFS V1.0 Smart Filament Sensor Detection module. All mounts use m3 screws lengths 6mm, 10mm, or 12mm.
You may need to offset the X Axis end stop back a little as it might miss the new mount and jam, with the mount sitting on the end stop housing and the original plate not triggering the switch. I fixed this with small spacers moving the end stop back a millimeter or two.
There is also a mount for a 5015 with a fan duct. This works independently of the mount and leaves the extruder gear exposed for manual feeding.
The author marked this model as their own original creation.