Snow Globe - Cat, with an optional custom display stand for freestanding use (Christmas ornament)

https://www.buymeacoffee.com/maxt

----------------------

2mm thick

The model will fit on Prusa Mini+ (180x180)
Feel free to size it up or down as you wish
I strongly suggest sizing it up to fit your entire heat bed as it gives the best result

The best quality is achieved if printed face down

Print: 0.2mm
Nozzle: 0.4mm
Perimeters: 2
Support: Not needed
Brim: Not needed
Infill: 10% (lots of bridging)
Fill pattern: Support Cubic
Solid layers, top: 2
Solid layers, bottom: 2
Minimum shell thickness, top: 0.4mm
Minimum shell bottom, top: 0.4mm
Seam position: Rear
These settings will save you at least 40% of the filament, and it will produce the same quality print.

A tip: If you want to get this print easily off your heat bed, place the heat bed with the printed model in the freezer for 10 to 30 mins. Take it out, and it should pop off quite easily without any breaks/cracks, as shown on the photo below :)



I've also included a custom stand to fit the Snow Globe :)
The mini version of the stand should be used only if the model can be placed somewhere without too much disturbance (maybe even behind a glass).
Otherwise use the normal version of the stand, it's pretty sturdy.
Infill: 10%

Happy Printing!

--------------

https://www.buymeacoffee.com/maxt