Imperial Helmet Stand

Found an Imperial Helmet Stand for my girlfriend on Thingiverse but it was too tall (even the “normal" one) for my printer. So I chopped it in half, edited a few small things, and printed it up for her Rex helmet I printed over the summer.

I used draft (0.28 layer), 10% grid infill, 4 layer bottom/top, 3 layer skin, PLA, and let it rip.

Since I did this in Tinkercad (Sorry OnShape, I still don't get you) so it'd be simply to adjust, and I would only have to adjust the top half and re-print, not the entire thing again.

The 501st test is just a gee-wizz. I printed it in Yellow with the helmet stand being black, and super glued it on once they were both done.

The Test Threads print is so you can see if your printer works with my allowances.

I'll post pictures as soon as I have them.