Prusa I3 MK3 OctoPrint Raspberry Pi 4 Einsy Case

Sooo, I took the pictures with this sitting on my mini, but I printed on my Ender 3. :D

EDIT 03-10-2020: Just added the Pi cover part because I just realized that I extended the face of the Pi case by 1.8mm and I did not change the cover to match. It's a small detail, but one that would annoy me.

Remixed the RPi 3+ case by lab27 to house an Rpi 4 as the RPi 3s are hard to come by now.

It's a tight fit, but I feel that is preferred. My test print is pictured. Post a comment if you're having trouble fitting the Pi and I can make some adjustments.

I have found that holding the Pi at an angle so the the USB connectors are protruding slightly, as shown in the pictures, then rotating it into place works well.

Also, I'm not sure what size screws the original design was intended to use, but I used the same size holes. I may be changing this though to better fit an M2 or an M2.5 or a thread forming screw. Suggestions welcome.

Here is lab27's thing: https://www.thingiverse.com/thing:3127643

You can print the remaining parts from lab27's files.

Enjoy!