@Ross_12082 Done. Please be kind, LOL... the design is a bit messy. I've learned a lot about 360 since I posted this and haven't had time to go back and make improvements.
@Ross_12082 Not necessary, but try this (just for learning). Right-click on Sketch3 in the browser and select Edit Sketch. Zoom way in so it's easy to see the dimensions (3.00mm & 2.5mm) on the two holes you want to swap. Double-click on the dimension and you should see an edit box. Enter 2.5 on the bigger one and 3.0 on the smaller one. You just swapped the two holes. Double-click on the text (the 4 & 5) and swap the values. And done!
Both of those holes are drilled to 75mm so you don't have to edit the extrusion. (edited)
Just what I needed for my Bondhus ball-head drivers.
Is there a chance you could reverse the locations of the 4mm and 5mm holes so the largest driver handle is then at the back of the block?
@Ross_12082 Sure. It'll probably take me a day or two to get to it -- very busy work week.
Hi Brenda,
Thank you.
Otherwise, if you have it in a Fusion 360 file I could make the alterations.
@Ross_12082 Done. Please be kind, LOL... the design is a bit messy. I've learned a lot about 360 since I posted this and haven't had time to go back and make improvements.
Hi Brenda,
Still learning F360 and couldn't understand what you had done back then (no doubt others would).
So I simply created a new F360 design and aligned the hexagonal holes.
How can I get a copy of my F360 file to you? (edited)
@Ross_12082 Not necessary, but try this (just for learning). Right-click on Sketch3 in the browser and select Edit Sketch. Zoom way in so it's easy to see the dimensions (3.00mm & 2.5mm) on the two holes you want to swap. Double-click on the dimension and you should see an edit box. Enter 2.5 on the bigger one and 3.0 on the smaller one. You just swapped the two holes. Double-click on the text (the 4 & 5) and swap the values. And done!
Both of those holes are drilled to 75mm so you don't have to edit the extrusion. (edited)