Dyson Attachment clip w/ screw

This thing is meant to fix/reinforce hcooh's Dyson V7/8/10 accessory rack found here:…
4
21
0
295
updated November 22, 2022

Description

PDF

This thing is meant to fix/reinforce hcooh's Dyson V7/8/10 accessory rack found here:

https://www.thingiverse.com/thing:2027523

It is a remix of Blkhawkdrv's clip, with a screw added and a rounded taper cut on top so the canister doesn't snag when pulling out the vacuum. The option to add a screw is there for added security, but not necessary to use. The hole is sized for M4 or #8 flathead screws. Using a screw requires a ~4mm hole to be drilled in the bottom of the charger housing for the screw to go through. For pictures that show what it does/how it fits, please see Blkhawkdrv's thing here:

https://www.thingiverse.com/thing:2783845

[update: It's now been about 4 years since I hung this thing on my garage wall; the 2-wall ABS print finally gave way and broke on my wife. The attachment holder part broke, where it slides into the hole on the dyson charger. Then my T-reinforcement part snapped near the bend on that side. I would consider this very durable, considering how unceremoniously the attachments get slammed in/out by everyone around the house. Since it was ABS and broke cleanly, I just lathered the cracked areas with liberal ABS pipe glue, clamped it up, and let it dry for 12hrs. Now it's back in use... and looks/feels stronger than it was before.]

Category: Organization

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License