Rotating display stand. Manual

A rotating display stand. 
At first I set out to design a coil wounded display stand. 
However, after I printed the coil, I realized that I am winding it up manually. And since that is the case I might as well just scrap that whole idea and make something that is a lot more simple. 

So with that, this is version 2. 

The only additional thing that is required is an 608zz bearing. 

As for printing, its a very basic model, no need for anything special. 
However for the top part, I would suggest some line supports, for the bearing spot. 
I like the line supports for overhangs like that, as they are very easy to remove afterwards. 
It has been designed with 0.2mm layer height in mind and 0.4mm linewidth. 

In the pictures you will notice that i have added some painters tape to the bottom part that hold the bearing. I did this because the tolerances were too loose. 
The uploaded part has this fixed. 

Some sci fi like markings have been added to the stand. Its both just for fun and, for me personally, to help me line up the objects to the middle of the disc.