This is the roof rafters of the VICTORIAN MANSION model. Depending on your printer, some components may require some minimum minor trimming.
I exclusively print with PLA and have found that ordinary clear lacquer thinner (Nail polish remover) is a wonderful glue. Make a small test for yourself of two pieces of printed scrap PLA and give it a try. Let sit for 20 seconds and then try to break it apart. It leaves no residue and is applied with a small brush. I've been using lacquer thinner as a glue on stryene and PLA for years. No sloppy or messy glue to show when finished. This build is the attic floor only, the roof rafters are currently in the design/test phase.
If you would like me to design a custom model for you contact me at:
garylavart@yahoo.com.
It is totally free but I will post it on Prusa Printables for others to print and enjoy.
The author hasn't provided the model origin yet.