CR6 SE Filament Sensor Riser and Guide for Creality Dual Gear Extruder

Just a simple remix to add the ability to use a M10 fitting. 

You need 2x M3 30mm screws

Instructions:

Print with supports!


For V1:
You should test to see if the filament goes through the end, but it probably won't! So you need to use some small hex keys or screwdrivers to clear the path for the filament. After enlarging the hole, test if the filament moves smoothly. You need to grow the hole until the filament moves freely enough.

For V2:
You don't need to make the hole bigger, I made that for you ;)

Original Files:
https://www.thingiverse.com/thing:4697116
https://www.thingiverse.com/thing:4865947