Milk Crate Planter - Vase Mode

There were lots of milk crate models but none that worked as planters or in vase mode. So I whipped this up.
 

Once it prints in vase mode, you'll notice that the top of each of the diamonds has a small gap. While this was not intended in the design, it actually makes for a great succelent planter as the soil with drain quicker as it is exposed to more air.

This includes a vase mode and non vase mode version. After the vase mode version prints you'll want to clip off the handles on the inside to make the handles go all the way through. This was the best way I could figure to make this work how I wanted.

I printed this on my Ender 5 Plus with a .4mm nozzle.