Sliding cigar ashtray / Zigarren Aschenbecher

A sliding ashtray for cigar smokers inspired by an existing design with a beautiful cubatabacco logo on the front.

The ashtray allows you to let the cigar rest and also catch the ash while it rests.

Its not designed as a pocket ashtray, rather as a table ashtray.

I wanted to add magnets in the lid so that it stays closed but I was happy with the final design. I attached the .f3d for you to remix it if you like (add magnets or exchange the logo).

The rough dimensions are 13 x 5,5 x 5,5 cm.

Beware that leaving the consumable in the tray to let it go out might deform the ashtray due to the heat. I haven't experienced it yet, just a heads up.

I printed both parts upright like they're shown in the STL with Prusament PLA and standard settings on a Prusa Mini. 

A bit sanding on the outside of the inner part is recommended so that it will move silently.