Simple Raspberry Pi HQ camera box

This is a very simple box for the new Raspberry Pi HQ camera module as I wasn't comfortable having a bare PCB flapping…
2h 0m
2× print file
0.15 mm
0.40 mm
22.00 g
32
495
9
3070
updated May 6, 2020

Makes

Comments

I used this design and made some alterations so that we could add an CSI to HDMI converter inside the box. Makes managing the cable a bit easier ( but needs another converter on the other end). Nice stl file. Prints really nice.

Note: the last picture shows the internals. I also had to design and print some other small parts. (edited)

An amazing cover for the Pi HQ camera, with a few tweaks, but everything seems to work fine. Many thanks.

Good solution to protect the camera.

Modify original design and install it to several churches around the czech republic to make streaming to youtube possible. Thanks

Great that this exists - but I struggled with the screws. It would be really good if it supported more common screws and fixings, for example: M3x8/M3x10 (or even M4!) machine screws - even as an alternative model (edited)

Source files are included if you need to change it, or just drill the pilot holes out for M3. Bigger than that seems unnecessary, they are not structural at all.

I have used M2 Pan Head Self Tapping Screws to finish the case. Four M2x6 for the camera module and four M2x10 for the lid.