As per questions below, support is needed, but it fits .. the magnets are on the way, so it is almost done and I will be able to carry it safely in any bag :)
- and yes, it is two color print
DJI Mini 3 Pro Case
Makes
Comments
@Orxion_408235 I found the 2mm magnets are too thin.. they sit down inside the holes...
A good fit. My only question, like someone else has raised, is the way up to print the lid.
How are you printing the lid for the best results
@AmpereSi_190800 As is with loads of support at the bottom. This way, the part that is visible outside has a nice finish.
@gyozamonstah_426355 I have found this to be a nightmare with both normal and tree supports... Bambu P1P