Spiral Helix Vase

I've created an attractive spiralized vase, available in three height variations.
Is this vase practical? No, not really… Not really at all… But it sure looks neat!  

Approximate variant height:
Short - 185mm
Standard - 310mm
Tall - 337.5mm

IMPORTANT TIP: If your printer exhibits stop-and-go behavior, pauses, or lags during spiralized/vase mode prints, try adding the command: M413 S0 ; at the start of the g-code in your slicer settings. This command will disable power interruption save states/checkpoints that can contribute to apparent slow-downs and hiccups during vase prints.

Other tips:
-Part cooling must be sufficient to support the extreme angles of these files
-Print speed may need to be reduced