the print came out great! I haven't ordered parts to build my Stealthburner yet but will add an update when I assemble and test it
Ender 3 Stealthburner with Clockwork2 mod
This is a remix of WouterE_ conversion plate.
65
348
1
3088
updated October 31, 2022
Makes
Comments
Hi, has a question, how did you handle the home offset after installing this hotend? Currently in my case the printing starts 4 cm in front of the table....
I tried the M206, and something helped, because the bltouch probe is perfectly in the center, but the printing continues to start in front of the table....
I am using the V6 hotend version and i noticed that it is kinda impossible to put in the lower screws on the posts. Is there a bit of help you can give me?
View 2 more comments
@Leiwandizer ah sorry i was just stupid. I didn’t think of the fact that 50mm m3 screws are the right length and go all the way through it. Sorry for the inconvenience 😅
@Kaffon_249927 Perfect - your welcome
wich x axis cover are you using?
@PeterGraaf_418871 it’s a changed construction from Thingiverse. I will publish it here soon.