Resin Print Curing Box

A curing box that can fit the entire print volume of my Epax X1 (or similar photon/mars). The door is magnetic, embedded are 16x2.5MM neodymium magnets I actually got at Daiso Japan, but 16x2mm magnets should work if you can't find those. The magnets attract to some m5 screws (2). You will want some kind of foil tape or something reflective to line the inside of the box (or at minimum print the box white), I just used aluminum foil tape.

The body ended up being just over 700G when sliced and printed, make sure you use an almost new spool and make sure that it has good adhesion to your bed, you don't want curling.

I used the following parts from amazon and some hardware I had on hand.

Switch

Power Jack

UV LED

Magnets

2x m5 (any type) screws (4-16mm, it doesn't matter).

2x m3 (any type) screws (10-22mm, it doesn't matter).

4x m3 flush head screws (8-20mm, it doesn't matter).

Would also recommend some rubber feet.

If you want to secure the LED to the frame you will need some longer m6 screws (18-20mm).

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

.3mm

Infill:

10%

Filament: Inland PLA Black, White

Notes:

The main box should be printed on it's back and you shouldn't need any supports as long as your printer is OK with bridging.

How I Designed This ===================

Sketchup

.SKB file included.

Category: 3D Printer Accessories