A simple slide-together two-piece breadbox with a nested slicing guide. Had some minor adhesion issues that didn't affect the interior at all, so I just ignored them. This was an insane print that took about 10 days to print and used 1.6 kilos of Tough PLA. Cost-wise, this was nuts, and I doubt I'd do it again. But I now have a sturdy breadbox sized to fit the 2lb loaves produced by my Zojirushi Home Bakery. :) The handle is optional, and I just glued it on with CA.
The original TinkerCAD design is at: https://www.tinkercad.com/things/dD8iAkBi57z-breadbox-slice-guide/edit
Printer Brand:
Ultimaker
Printer:
Ultimaker 3
Rafts:
No
Supports:
No
Resolution:
.2 mm
Infill:
40%
Filament: Ultimaker Tough PLA Red, Black
Category: Kitchen & DiningThe author marked this model as their own original creation. Imported from Thingiverse.