Click Probe - To level your print bed
My vision of a probe to level the bed, but simpler than other designs
3
20
0
782
updated January 12, 2023
Description
PDFIt is a Klicky style probe for leveling the print bed, but simpler.
You will need: Four magnet that are 4mm thick, 6mm in diameter and press fitted.
One washer that goes on the back of the probe dock with some CA glue.
Two M3 Nuts and 2 M3 screws. Two small screws for mounting the switch to the probe.
One connector for your board of choice.
Some wire, are used to connect the magnet with the switch, and again from the magnets in the probe arm to the board. The wire are only soldered to the switch
Tags
Model origin
The author marked this model as their own original creation.
