Case for NanoVNA V2

This case for the NanoVNA V2 needs at least four 1.4x10mm screws but looks better with 8 screws.

Rubber feet can be printed in TPU and might be fixed with a drop of epoxy. As the TPU tends to draw strings there is a single foot for a single print out with less strings.

Additional STL with writing on the top can be added, if a multi material printer is available.

The case may need a bit of filing and sanding on the support bottom wedges - depending on the tolerances of the PCB stack. This is especially important in case of touchscreen malfunctions due to too mechanical stress on the display.

Flip the two main parts by +/-90 deg.

Enjoy!