Needed a way to mount my ratchet set to the wall without screwing or otherwise damaging the wall.
Decided to design a mount that uses command hook strips that could support the ratchet set as well as a palm ratchet.
A little worried if it could carry the weight at first, but it has been holding well for a couple months with no sign of failing.
I printed it with the base flat against the build plate and used a fairly high support density to give the adhesive a better surface to mount to.
Printer Brand:
Creality
Printer:
Ender 3 Pro
Supports:
Yes
Resolution:
0.2
Infill:
25%
Filament:
Overture PETG or PLABlue
Notes:
As stated in the description, I printed the support for the bottom pocket at a pretty high density to give a better surface for the command hook to mount to. Currently adjusting the part cooling ducts on my printer so this might not be a problem for you.
Printed in PETG mainly because it was loaded at the time, should be fine in PLA, but I haven't tested it. Category: Tool Holders & BoxesThe author marked this model as their own original creation. Imported from Thingiverse.