U.S. Navy - Petty Officers - 3rd, 2nd, 1st Class

These were designed with a flat-back to become wall, door, or bookcase mountable.    The height of these designs, while laying on it's back, is 8.5 mm with the width at 100 mm.  You can resize/rescale it for your printing pleasure.

You can now download the the Split or Whole version of each rank insignia.  Why the Split?  So you can print in different colors (See Pictures)!  The "Whole" version is label with ". . . USN_RithM" for each rank.

Recommend using the “Z Hop - Retraction” setting in order to print well.  I used the following retractions for this design from the Cura Slicer:

Print Travel:  *Please note, the setting below may increase the print time!**

Enable Retractions:  Yes

Retract at Layer Change:  Yes

Avoid Printed Parts While Traveling:  Yes (This helps a little to avoid Stringing)

Z Hop When Retracting:  Yes

Z Hop Height:  0.3

Shout out to all my Devil Dolphins holding down the seas from ship to shore!