autococker pre 2k pump kit

this a basic 3d printed pump kit for pre 2k autocockers
you will need a 3/8-24 screw to replace the banjo and thread tape it

for the pump arm its easier if you use a extra one and you will need a 6-32 by 3 ½ inch screw

and for the pump rods you will need some ¼-20 screw by at least 3 inches could be longer as you need to cut down the head as the pump handle will slide on the rods

this is a work in progress it still missing a way attach the 6-32 screw to the handle , i used a screw but yould 3d print something or use epoxy

use petg asa or something strong and heat resistant