KTM GS350 Parts

I printed the handgrip for the rear fender so the bike can be handled better.

The sprocket cover is an upgraded replacement for the original one.

The kickstarter boot and the nipple covers I printed in Filaflex shore 82a TPE, which is very soft and stretchy flexble filament. I printed these on my prusa mini. 

The kickstart boot protects the cylinder and shins from the crank smashing it to bits.  

The  reedvalve insert will increase performance, it helps the reedvalve open at low rpm's.
The stock reedvalve and insert are to big and cause the gassen to hit the plates at a low velocity. This insert will mix the mixture better and increase the speed of the gasses.
I recommend printing it in PETG because that can withstand fuel and oil.

Don't forget to post a make and give this model a rating, I love seeing those!