Pelmet

Pelmet designd for IKEA BEKRÄFTA rod. Ceiling mount system instead of wall mount from IKEA. 

There is two diferrent size of socked based on diameters of each side of rod.
Wall interface is same for both diameters.
Each wall interface need two screws for the wall (3.5-4mm screw diameter)
Also you will need for each pair of “wall interface and socket” 1 x M8x35mm and 1x M8 nut.

M8 Nut is inserted during the print of the wall interface. Just put pause in slicer in layer height of the bridge over the nut.

M8 Screw is pushed into socked after print finished print.

For the print I chosed white PETG with 4 perimeters, no support, 35% infill.